config system debug-filter
The config system debug-filter command allows you to filter logging of packet and SQL processes.
Enabling debug filters has an impact on system performance.
For information on other debugging commands, see diagnose on page 1.
Syntax
config system debug-filter
edit <seq_num>
set dst-ip <dst-ip_ip>
set dst-port <dst-port_int>
set ingress-intf {port1 | port2 | port3 | port4 | port5 | port6}
set protocol {tcp | udp}
set src-ip <src-ip_ip>
set src-port <src-port_int>
end
where:
| Keywords and variables | Description | Default |
|---|---|---|
<seq_num>
|
Enter an unused filter number to create a new route. Enter an existing filter number to edit that route. |
None |
<dst-port_int>
|
Enter the packet destination IP address to match. | None |
<dst-port_int>
|
Enter the packet destination port to match. | None |
{port1 | port2 | port3 | port4 | port5 | port6}
|
Specify the interface on which FortiDB receives traffic that it applies this filter to. | None |
{tcp | udp}
|
Specify the packet layer 4 protocol to match. | None |
<src-port_int>
|
Enter the packet source IP address to match. | None |
<src-port_int>
|
Enter the packet source port to match. | None |