Before using FortiAuthenticator-VM, you need to install the VMware application to host the FortiAuthenticator-VM device. The installation instructions for FortiAuthenticator-VM assume you are familiar with VMware products and terminology.
FortiAuthenticator-VM is compatible with HyperV Windows Server 2012 and 2016. For information on the FortiAuthenticator-VM system requirements, please see the FortiAuthenticator datasheet.
FortiAuthenticator-VM has kernel support for more than 4GB of RAM in VM images. However, this support also depends on the VM player version. For more information, see http://kb.vmware.com/selfservice/microsites/search.do?language=en_US&cmd=displayKC&externalId=1014006
The default Hardware Version is 4 in order to support the widest base of VM players. However you can modify the VM Hardware Version by editing the following line in the FortiAuthenticator-VM.vmx file:
The following procedure describes setup on VMware Fusion.
- Download the VM image zip file to the local computer where VMware is installed.
- Extract the files from the zip file into a folder.
- In your VMware software, go to File > Open.
- Navigate to the expanded VM image folder, select the FortiAuthenticator-VM.vmx file, and select Open.
- At the FortiAuthenticator login prompt, enter
adminand press Enter. By default, there is no password, however, a password must be set before you can proceed. Enter and confirm the new administrator password.
- At the CLI prompt enter the following commands:
config system interface
set ip <ip-address>/<netmask>
set allowaccess https ssh
config router static
set device port1
set dst 0.0.0.0/0
set gateway <ip-gateway>
VMware will install and start FortiAuthenticator-VM. This process can take a minute or two to complete.
You can now connect to the GUI at the IP address you set for port 1.
|Suspending the FortiAuthenticator-VM can have unintended consequences. Fortinet recommends that you do not use the suspend feature of VMware. Instead, shut down the virtual FortiAuthenticator system using the GUI or CLI, and then shut down the virtual machine using the VMware console.|