Fortinet Document Library

Version:

Version:

Version:

Version:

Version:

Version:

Version:

Version:

Version:

Version:

Version:

Version:

Version:

Version:

Version:

Version:

Version:

Version:

Version:

Version:

Version:

Version:


Table of Contents

Administration Guide

Testing the Google Cloud connector example

You can use the CLI console to test the cloud connector before the logs have rolled over or a scheduled backup is performed.

To test a cloud connector:
  1. Open the CLI console and type: diag test application uploadd 62 <connector name> <bucket name>.

    If the connector is working, the output will show success.

  2. Go to the storage bucket on Google Cloud and look for the test files you uploaded.
To test a cloud connector with a shell prompt:
  1. With the default settings, access to shell will give the following message:

    FAZ1000D # execute shell

    Shell disabled.

  2. Use the following commands to enable shell on the FortiAnalyzer:

    FAZ1000D # config system admin setting

    (setting)# set shell-access enable

    Enter new password: *****

    Confirm new password: *****

    FAZ1000D # end

  3. The shell is now enabled.

    FAZ1000D # execute shell

    Enter password:

    sh-4.3#

    sh-4.3#

    Open the CLI console on any page and type: rclone --config=/drive0/private/rclone.cfg ls <connector-name>:<bucketname>

    If the connector is working, you will not see any errors.

Testing the Google Cloud connector example

You can use the CLI console to test the cloud connector before the logs have rolled over or a scheduled backup is performed.

To test a cloud connector:
  1. Open the CLI console and type: diag test application uploadd 62 <connector name> <bucket name>.

    If the connector is working, the output will show success.

  2. Go to the storage bucket on Google Cloud and look for the test files you uploaded.
To test a cloud connector with a shell prompt:
  1. With the default settings, access to shell will give the following message:

    FAZ1000D # execute shell

    Shell disabled.

  2. Use the following commands to enable shell on the FortiAnalyzer:

    FAZ1000D # config system admin setting

    (setting)# set shell-access enable

    Enter new password: *****

    Confirm new password: *****

    FAZ1000D # end

  3. The shell is now enabled.

    FAZ1000D # execute shell

    Enter password:

    sh-4.3#

    sh-4.3#

    Open the CLI console on any page and type: rclone --config=/drive0/private/rclone.cfg ls <connector-name>:<bucketname>

    If the connector is working, you will not see any errors.