Testing the Google Cloud connector

You can use the CLI console to test the cloud connector before the logs have rolled over or a scheduled backup is performed.

To test a cloud connector:

1. Open the CLI console and type: diag test application uploadd 62 <connector name> <bucket name>.

   If the connector is working, the output will show success.
   

2. Go to the storage bucket on Google Cloud and look for the test files you uploaded.
   

To test a cloud connector with a shell prompt:

1. With the default settings, access to shell will give the following message:

   FAZ1000D # execute shell

   Shell disabled.

2. Use the following commands to enable shell on the FortiAnalyzer:

   FAZ1000D # config system admin setting

   (setting)# set shell-access enable

   Enter new password: *****

   Confirm new password: *****

   FAZ1000D # end

3. The shell is now enabled.

   FAZ1000D # execute shell

   Enter password:

   sh-4.3#

   sh-4.3#

   Open the CLI console on any page and type: rclone --config=/drive0/private/rclone.cfg ls <connector-name>:<bucketname>
   

   If the connector is working, you will not see any errors.