show commands display a part of your Fortinet unit’s configuration in the form of commands that are required to achieve that configuration from the firmware’s default state.
Although not explicitly shown in this section, for all
Commands and variables are case sensitive.
show does not display settings that are assumed to remain in their default state.
The following examples show the difference between the output of the show command branch and the get command branch.
Example show command
show system dns
config system dns
set primary 184.108.40.206
set secondary 220.127.116.11
Example get command
get system dns
primary : 18.104.22.168
secondary : 22.214.171.124