Initial set up
Initial set up
To connect to the FortiAnalyzer-BigData GUI:
- Install the SFP RJ45 transceiver module into one of the SFP interfaces on the FortiAnalyzer-BigData Switch Module #2.
- Connect the RJ45 port on the transceiver module to the management computer using the supplied Ethernet cable.
- Enable DHCP or set the management computer's IP address to be on the same subnet as FortiAnalyzer-BigData.
For example:
- IP address: 192.168.1.10
- Netmask: 255.255.255.0
- On the management computer, open a supported web browser and visit https://192.168.1.99.
- Log in with the username
admin
and no password.
The FortiAnalyzer-BigData GUI loads.
Initial set up
To connect to the FortiAnalyzer-BigData GUI:
- Install the SFP RJ45 transceiver module into one of the SFP interfaces on the FortiAnalyzer-BigData Switch Module #2.
- Connect the RJ45 port on the transceiver module to the management computer using the supplied Ethernet cable.
- Enable DHCP or set the management computer's IP address to be on the same subnet as FortiAnalyzer-BigData.
For example:
- IP address: 192.168.1.10
- Netmask: 255.255.255.0
- On the management computer, open a supported web browser and visit https://192.168.1.99.
- Log in with the username
admin
and no password.
The FortiAnalyzer-BigData GUI loads.