Configure SNMP v3
To configure SNMP v3:
- Go to System > SNMP.
- Click the SNMPv3 tab.
- Complete the configuration as described in SNMP v3.
- Save the configuration.
|Name||User name that the SNMP Manager uses to communicate with the SNMP Agent. After you initially save the configuration, you cannot edit the name.|
|Status||Enable/disable the configuration.|
|SNMP v3 Port||Enter the port number on which the system listens for SNMP v3 queries from the SNMP managers. The default is 161.
Enter the subnet address for the SNMP manager to be permitted to query the FortiADC system. SNMP managers have read-only access. You can add up to 8 SNMP managers to each community. To allow any IP address using this SNMP community name to query the FortiADC system, enter
|Test both traps and queries (assuming you have enabled both). Traps and queries typically occur on different port numbers, and therefore verifying one does not necessarily verify that the other is also functional.
To test queries, from your SNMP manager, query the FortiADC appliance.
To test traps, cause one of the events that should trigger a trap.