config system alert-policy

Use this command to configure system alert policies.

Before you begin:

You must have read-write permission for system settings.

Syntax

config system alert-policy

edit "alert_policy_name"

set status {enable|disable}

set action <datasource>

set comments comments

config alert-member

edit "alert_member_name"

set status {enable|disable}

set alert-name <datasource>

set alert-action-inherit {disable|enable}

set action <datasource>

next

end

next

end

Policy
alert_polciy_name	The name of an alert policy configuration.
status	Enable or disable the alert policy.
action	Set the alert action for the entire policy. Note: Alert actions include syslog, email, and snmp trap, which can be configured using "config system alert-action". The action you set here affects all members.
Member
alert-member-name	The name of a member of an alert policy.
status	Enable or disable an alert-member.
alert-name	The name of an alert configuration.
alert-action-iherit	Enable or disable. Note: If enabled, the alert policy member will inherit the action set in the alert policy.
action	Set the action for the alert policy member. Note: Alert actions include syslog, email, and snmp trap, which can be configured using "config system alert-action". The action you set here affects the policy-member only.

Example

config system alert-policy

edit "disk"

set status disable

set action all

config alert-member

edit "1"

set alert-name disk

set alert-action-inherit disable

set action all

next

end

next

end