config load-balance reputation-black-list

Use this command to create a new ip-reputation black list. If enabled, the specified IP address or range of IP addresses will not be allowed to pass through.

Before you begin:

• You must have read-write permission for load balancing feature settings.

Syntax

config load-balance reputation-black-list

config entries

edit <No.>

set status {enable|disable}

set type { ip-netmask|ip-range}

set ip-network <ip&netmask>

set end-ip <ip>

set start-ip <ip>

next

end

status	Enable or disable the exception. You might have occasion to toggle to exception off and on.
type	ip-netmask: address block ip-range: address range
IP/Netmask	If IP/netmask is selected in the Type field above, specify a subnet using the address/mask notation.
start-ip	Specify the start of an address range.
end-ip	Specify the end of an address range.