Fortinet Document Library

Version:

Version:

Version:

Version:

Version:


Table of Contents

Handbook

Configuring a Prefix List

FortiADC D-Series units support IPv4 prefix lists over BGP routing. If you are configuring BGP routing using IPv4, you must configure access lists using the IPv4 protocol.

To configure a Prefix list:
  1. Go to Network > Routing.
  2. Click the Prefix List tab.
  3. Click Create New.
  4. Enter a unique name for the new access list. Note: The name can be up to 35 alphanumeric characters long, including . (period) , : (colon), _ (underscore), and - (hyphen). No space is allowed.
  5. Enter a brief description of the access list. Note: The description can be up to 1023 alphanumeric characters long, with no restriction on use of special characters. Space between characters is allowed.
  6. Click Save.The newly created access list entry appears in the access list table.
  7. Click the Edit button to open the Prefix List dialog.
  8. In the Rule pane, click Create New. The Prefix List > Edit Rule tab pens.
  9. For Action, select the Permit or Deny radio button.
  10. For IPv4 Prefix, enter the IPv4 address/subnet mask in the format of 0.0.0.0/0.
  11. For GE, set the GE (greater than and equal to) values.
  12. For LE, set the LE (less than and equal to) values
  13. Click Save when done.
  14. Repeat Steps 8 through 13 above to add as many rules to the access list as needed.
  15. Click X to close the Prefix List dialog when done.

Configuring a Prefix List

FortiADC D-Series units support IPv4 prefix lists over BGP routing. If you are configuring BGP routing using IPv4, you must configure access lists using the IPv4 protocol.

To configure a Prefix list:
  1. Go to Network > Routing.
  2. Click the Prefix List tab.
  3. Click Create New.
  4. Enter a unique name for the new access list. Note: The name can be up to 35 alphanumeric characters long, including . (period) , : (colon), _ (underscore), and - (hyphen). No space is allowed.
  5. Enter a brief description of the access list. Note: The description can be up to 1023 alphanumeric characters long, with no restriction on use of special characters. Space between characters is allowed.
  6. Click Save.The newly created access list entry appears in the access list table.
  7. Click the Edit button to open the Prefix List dialog.
  8. In the Rule pane, click Create New. The Prefix List > Edit Rule tab pens.
  9. For Action, select the Permit or Deny radio button.
  10. For IPv4 Prefix, enter the IPv4 address/subnet mask in the format of 0.0.0.0/0.
  11. For GE, set the GE (greater than and equal to) values.
  12. For LE, set the LE (less than and equal to) values
  13. Click Save when done.
  14. Repeat Steps 8 through 13 above to add as many rules to the access list as needed.
  15. Click X to close the Prefix List dialog when done.